AvocadoXL 220 Racing Drone Kit
The AvocadoXL is an experiment in frame design where the battery sits in an internal compartment at a 45-degree angle. This battery placement enables the center of gravity and moment of inertia to be sequestered right in the middle of the prop line. Many have noticed flight characteristic benefits from this balancing act. We've seen the quad respond quicker and smoother to controller input which is attributed to not have as much mass above or below the quadcopter to throw around ( making it more localized to the moment of inertia )
As this frame tries to shrink the overall size while holding a battery in the middle, there isn't much room for extra components. Currently, it only supports a single stack flight controller, small receiver and mid-sized video transmitters like the TBS Unify Pro. You can attempt to use multiple stacked flight controller system, but it may protrude too far from the top of the frame into the prop line.As the Flight controller sits
As the Flight controller sits at a 45° angle on top and away from the ESCs, this frame is not conducive to PDB or all in one flight controller system. ESCs go under the arms and are connected to the supplied PDB. For details on how to assemble the frame visit the assembly guide.
$30 CLEARANCE PRICING
Due to the nature of this clearance, I'll be fulfilling orders color options are the quantities of those 3D printed parts last. Please read the full product description to fully understand what comes with the kit. If you want arm bumpers make sure to purchase those separately.
Many kits will come with two wire harnesses, one short colored one that you can extend the wires on, or a partially colored or uncolored full wire length harness. Many of the harnesses will not be assembled and will require pushing cables into connectors. This was done to save time on assembling these clearance kits.
- Motor Diagonal 220mm stretched X frame
- 4mm unibody base plate
- 2.5mm side panels
- Prop Size 5"
- Dry Weight 350g (all components)
- Average AUW 550g (with 200g battery)
- Battery Sizes 1300-1500mAh
37x35mm battery compartment opening
- Default Camera Tilt 45°
- Session Mount at 45°
- Custom PDB and 5V pololu regulator support
- Base plate
- 2x side panels
- Flight controller plate
- 2x 40mm side panel standoffs
- 2x camera mount panels
- 6x varied nylon standoffs (2-4mm)
- 2x lock nuts for camera panels
- 2x 12mm M3 camera mount screws
- Custom PDB
- Battery cable kit ( xt-60 connector )
- 4x 8m M3 side panel screws
- Neoprene battery wall
3D printed parts
- Battery grommet
- Battery strap
- Battery cable stress relief band
- Flight controller cover
- VTX compartment cover
The color you select for the kit will be used for all the included 3D printed parts. If you would like to mix the colors please leave a note on the order. You can however easily select a different color for the arm bumpers!
Visit the links below to add additional parts to your order.
Optional parts ( not included )